technical data sheet 1/3 straight plug clamp type r114.003.133 cable 2/50 s series : smb issue : 0039 b in the effort to improve our products, we reserve the right to make changes judged to be necessary. all dimensions are in mm. .. pn ao components body center contact outer contact insulator gasket others parts - - materials brass beryllium copper beryllium copper ptfe - brass - - platings ( m) gold 0.2 over nickel 2 gold 1.3 over nickel 2 gold 0.5 over nickel 2 gold 0.2 over nickel 2 - -
technical data sheet 2/3 straight plug clamp type r114.003.133 cable 2/50 s series : smb issue : 0039 b in the effort to improve our products, we reserve the right to make changes judged to be necessary. packaging standard unit o ther 100 ?w? option contact us electrical characteristics impedance 50 ? frequency 0-4 ghz vswr 1.30 + 0.040 x f(ghz) maxi insertion loss 0.25 f(ghz) db maxi rf leakage - ( 57 - f(ghz)) db mini voltage rating 250 veff maxi dielectric withstanding voltage 750 veff mini insulation resistance 1000 m ? mini mechanical characteristics center contact retention axial force ? mating end 10 nmini axial force ? opposite end 10 nmini torque na n.cm mini recommended torque mating na n.cm panel nut na n.cm clamp nut 70 n.cm a/f clamp nut 5.500 mm mating life 500 cycles mini weight 3.000 g environmental operating temperature -65/+165 c hermetic seal na atm.cm3/s panel leakage na specification cable assembly stripping abcdef m m 2.00 1.00 4.00 3.20 2.00 0.00 assembly instruction : recommended cable(s) rg 178 rg 196 rg 178 lc kx 21 cable retention - pull off 58 nmini - torque 3.9 n.cm tooling part number description hexagon .. . others characteristics -
technical data sheet 3/3 straight plug clamp type r114.003.133 cable 2/50 s series : smb issue : 0039 b in the effort to improve our products, we reserve the right to make changes judged to be necessary. components body stripping dimensions centre contact back nut insulator clamp braid a b c d e 1 4 2 slide the back nut onto the cable. strip the cable. cut 2 slots in the jacket if necessary. slide the clamp braid sleeve between the cable dielectric and the braid. cut the braid flush with the clamp braid sleeve. slide the spacer onto the cable. slide the centre contact on until it bottoms against the cable dielectric. 2 1 2 3 1 2 1 screw sub-assembly into the connector body with the adapted wrench. 5 1 1 solder the centre contact onto the inner conductor. slide the back nut over the cable assembly. 3
|